Automatic two-sided printing (duplexing) path (HP LaserJet
3390/3392 all-in-one)
To clear a jam in the automatic two-sided path, perform the following steps:
CAUTION
Do not use sharp objects, such as tweezers or needle-nose pliers, to remove
jams. Damage caused by sharp objects will not be covered by the warranty.
When removing jammed media, pull the jammed media straight away from the all-in-one.
Pulling jammed media out of the all-in-one at an angle can damage the all-in-one.
1.
Open the rear output door.
2.
Rotate the green pressure release levers downward.
3.
Remove tray 2.
ENWW
Clearing jams
317
4.
Push down on the green lever on the automatic two-sided path door on the front of the all-in-one.
5.
With both hands, grasp the side of the media that is most visible (this includes the middle), and
carefully pull it free from the all-in-one.
6.
Close the automatic two-sided path door.
7.
Reinsert the main input tray (tray 2).
318
Chapter 13 Troubleshooting
ENWW
8.
Close the rear output bin, and then open the automatic two-sided path door on the back of the
all-in-one.
9.
With both hands, grasp the side of the media that is most visible (this includes the middle), and
carefully pull it free from the all-in-one.
10.
Close the automatic two-sided path door.
ENWW
Clearing jams
319