Using manual dial
Usually, the all-in-one dials after you press
Start Fax
. At times, however, you might want the all-in-
one to dial each number as you press it. For example, if you are charging your fax call to a calling
card, you might need to dial the fax number, wait for the acceptance tone of your telephone
company, and then dial the calling card number. When dialing internationally, you might need to dial
part of the number and then listen for dial tones before continuing to dial.
To use manual dial with the automatic document feeder (ADF)
1.
Load the document into the automatic document feeder (ADF) input tray.
2.
On the all-in-one control panel, press
Start Fax
.
3.
Begin dialing.
NOTE
The all-in-one dials the number as you press each digit. This allows you to wait
for pauses, dial tones, international-access tones, or calling-card-acceptance tones
before continuing to dial.
To use manual dial with the flatbed scanner (HP LaserJet 3050/3052/3055 all-in-one)
1.
On the all-in-one control panel, press
Start Fax
.
The control-panel display shows the following message: Send from glass? 1=Yes 2=No.
2.
Press
1
to select YES. The control-panel display shows the following message: Load page:X
Press , where X is the page number.
3.
Scan a page into memory by placing the sheet print-side-down on the flatbed scanner and
pressing . After scanning the page, the all-in-one control-panel display shows the following
message: Another page? 1=Yes 2=No.
4.
If you have more pages to scan, press
1
to select YES, and then repeat step 3 for each page of
the fax job.
-or-
If you are finished, press
2
to select NO, and then go to the next step.
5.
When all pages are scanned into memory, begin dialing. The all-in-one dials the number as you
press each digit. This allows you to wait for pauses, dial tones, international access tones, or
calling card acceptance tones before continuing to dial.
ENWW
Basic fax features and tasks
73